Lecturer(s)
|
-
Krayem Said, prof. Ing. CSc.
-
Mizera Aleš, doc. Ing. Ph.D.
-
Mach Václav, Ing. Ph.D.
|
Course content
|
- Industrial and service robots mechanic set-up parts description- manipulator, wrist, mobile subsystem. - Arm and its possible shapes (constructive, material), joint and its constructive ordering- rotational, translational, combination. Common joints as rotational and translational joints system. - Manipulator and wrist lay-out. Manipulator possible configurations. Wrist with 1, 2 and three freedom degrees. Relation to the Euler theorem. - Active joint creation. Actuator types and placement. - Passive joint creation. Possible make-up, plane and spatial paralelogram. - Robots technological parts. Efektors. Types. - Grippers, technological effectors, combination. - Service robots mobile subsystems standard types. - Wheel and walking mobile subsystem principles and real solution. - Belt mobile subsystem principle and real solution. - Flying service robot subsystem principle and real solution. Free body in 3D space and its motion control methods. - Case study.
|
Learning activities and teaching methods
|
Monologic (Exposition, lecture, briefing), Exercises on PC, Individual work of students
- Participation in classes
- 42 hours per semester
- Term paper
- 20 hours per semester
|
prerequisite |
---|
Knowledge |
---|
Vectorial analysis in 2D and 3D middle school knowledge is supposed , work with PC - vector graphics, basic knowledge about constructional materials and their characteristics |
Vectorial analysis in 2D and 3D middle school knowledge is supposed , work with PC - vector graphics, basic knowledge about constructional materials and their characteristics |
learning outcomes |
---|
After study graduation students will manage the basic activities in software environment with vectorial graphics for 3D modelling and construction from robots mechanic layout areas and mechanic lay - out context and motion control. |
After study graduation students will manage the basic activities in software environment with vectorial graphics for 3D modelling and construction from robots mechanic layout areas and mechanic lay - out context and motion control. |
teaching methods |
---|
Individual work of students |
Monologic (Exposition, lecture, briefing) |
Monologic (Exposition, lecture, briefing) |
Individual work of students |
Exercises on PC |
Exercises on PC |
assessment methods |
---|
Written examination |
Written examination |
Recommended literature
|
-
Kárník,L. Praktické aplikace servisních robotů. FS V3B-TU Ostrava, 2011. ISBN 978-80-248-2727-8.
-
Palko,A., Smrček,J. Robotika- Koncové efektory pre priemyseľné a servisné roboty. Strojnícká fakulta TU v Košicích, 2004. ISBN 80-8073-218-3.
-
Skařupa, J. Průmyslové roboty a manipulátory. Vysoká škola báňská ? Technická univerzita, Ostrava, 2007. ISBN 978-80-248-1522-0.
-
Skařupa, J. Roboty a manipulátory. Vysoká škola báňská ? Technická univerzita, Ostrava, 2012. ISBN 978-80-248-2613-4.
-
Úředníček,Z. Opory na LMS systému. Zlín, 2019.
|